Can a nitrogen regulator be used for CO2?
Nitrogen and CO2 regulators cannot be interchanged because Nitrogen regulators are designed to withstand higher pressures and have characteristics specific only to nitrogen systems, such as a male thread with conical fittings. If you plan to dispense beer using Nitrogen, you cannot use a CO2 regulator.
What is the normal pressure for the CO2 tank?
about 860 psi
CO2 cylinder pressure is about 860 psi at normal room temperature. Typical CO2 cylinders store about 50 lbs.
What should the CO2 pressure be for draft beer?
between 12-14 lbs
Most breweries in the U.S. recommend a CO2 pressure between 12-14 lbs for ale and lager types of draft beers. This CO2 pressure will maintain the level of carbonation specified by the brewery.
What pressure should a full CO2 tank read?
10-12 PSI
Q: At what pressure should I run my CO2 regulator? A: For the standard 5 ft. run found in kegerators and most kegerator conversions, 10-12 PSI is recommended.
Do you need a secondary regulator?
You will need a secondary regulator if you are pouring from different kegs which require different amounts of pressure. Secondary regulators do not connect directly to the gas tank. They are additions which can be added after the primary regulator is already in place.
What PSI should a kegerator be?
We recommend setting the regulator at 12 PSI. NOTE: On regulators designed for draft beer, turning clockwise will increase the output pressure, and turning counter-clockwise will decrease the output pressure. Under normal circumstances we recommend setting the regulator at 12 PSI.
How much PSI is in a 12g CO2 cartridge?
Below 87.8°F, a 12 gram CO2 cartridge contains a mixture of liquid and gaseous CO2 in equilibrium. When the gaseous CO2 expands, some of the liquid CO2 immediately boils to take its place. As long as liquid remains, the operating pressure will be the vapor pressure of CO2 at the current temperature (usually 800+ PSI).
Is CO2 cheaper than nitrogen?
In simple terms, nitrogen costs less than CO2 – a lot less. Brewers are typically paying about $0.10 to $0.15 CCF using on-site nitrogen generation. You can easily compare this number to what you’re paying today for CO2 in gas cylinders, which can easily cost 50X this amount.
Can you use CO2 for beer gas?
Beer gas blends are typically a mixture of nitrogen and carbon dioxide (CO2) gas that are used to dispense draft beer from the taps. Mixes can vary in different degrees of nitrogen to carbon dioxide ratios. For example, nitro infused beers use a higher percentage of nitrogen for the gas mix.
What should I set my CO2 regulator at?
What PSI should a CO2 tank be at?
CO2 cylinder pressure is about 860 psi at normal room temperature. Typical CO2 cylinders store about 50 lbs.
What is the difference between a first and second stage regulator?
The first stage of the regulator is the part of the regulator that attaches directly to the cylinder, this reduces the pressure of the air from the cylinder down to an intermediate pressure held in the hose which connects to the second stage of the regulator, the second stage of the regulator sometimes called the …
How do I know which gas regulator I need?
How to choose a gas regulator. Check the appliance itself or the original paperwork for guidance. There should be a data plate outlining the required gas throughput and inlet pressure. Check the type of gas you’re using.
What should CO2 be set at for kegerator?
What pressure should my CO2 tank be set to? This will depend on the beer you are serving but most American breweries recommend a pressure between 10-14 PSI.
Why is my beer so foamy from my keg?
When the temperature rises above 40 degrees, the CO2 gas starts to escape from the beer, and this is what causes foam (in most cases). For this reason, temperature issues constitute the great majority of problems with kegerators serving foamy beer.