How does Compustar remote work?
On most push-to-start vehicles, Compustar remote starters use a secure, proprietary technology called KLON* that mimics your vehicle’s smart-key signal to start your engine. Thus, when you remote start your push-to-start vehicle, your engine will start as if your smart-key was physically inside of your vehicle!
How do I reset my Compustar alarm remote?
You must cycle the vehicle’s ignition between the on and acc/off position 5 times within 7 seconds or less and then tap the lock button, button I, or put the battery in the remote (2WSSR / P2WSSR). The process depends on which remote(s) you have. All your remotes must be reprogrammed at the same time.
How do you remote start a car with a key fob?
To remote start your vehicle:
- Press the Lock button on your key fob to lock all the doors.
- Press the Remote Start button (2X) twice. Steps must be done within 3 seconds. The exterior lamps will flash twice and the vehicle will start.
What is valet mode on Compustar?
Valet mode is a setting in Compustar and Arctic Start systems that will shut down the alarm system and the remote starter. It will only allow the remotes to retain key-less entry to be used to lock and unlock the doors.
Does remote start unlock doors?
Once remote engine start has been initiated, the doors will remain locked until the user unlocks the door themselves using their key fob, or sends a request in the app. Was this answer helpful?
How do you use a remote?
Use your phone as the remote for your Android TV
- On your Android phone, open the Google TV app .
- Near the bottom right, tap Remote .
- At the top, tap Scanning for devices.
- Choose your device.
- To complete pairing, follow the instructions on your phone and TV.
- After pairing, you can use your phone or your remote.
How many remotes can I program to my Compustar system?
Programming Multiple Remotes: After the confirmation flash given in STEP 2, you can code additional remotes by tapping the Lock button on the remote(s). The parking lights will flash once confirming each additional remote. The CM-900 can store up to 4 remotes. Exiting Programming: Programming is a timed sequence. The
How do I Reset my Compustar remote starter?
How do I reset my remote starter after changing the battery? Press and hold the “Lock” button on your fob remote car starter for one second. Turn your key to the “Off” position — the car lights should turn off. Do this within five seconds of turning the key to the “On” position and don’t remove the key once you’ve turned it to the “Off” position.
How to change time on Compustar remote?
Check/replace remote batteries. If your remote has USB port,plug it into a USB charger and then try again later.
How to replace the battery in a Compustar remote?
cover without damaging the circuit board. Your battery size should be listed on the sticker on the remote. (Battery size: 2 x CR2025) IMPORTANT: Be sure to observe correct polarity when installing the battery. One Way Remotes: Use a quarter or flat head screwdriver to pry open the remote. You can insert the quarter or flat head